Xbox controller works in Emulationstaion, but not fba, mame, snes.

Welcome Page Forums RetroPie Project Controller Configuration in RetroPie Xbox controller works in Emulationstaion, but not fba, mame, snes.

This topic contains 1 reply, has 1 voice, and was last updated by  g0nz0uk 2 years, 8 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #97179

    g0nz0uk
    Participant

    Hello,

    I have a Pi 2 using Retropie 3.0 beta 2.

    I have an Xbox 360 wireless controller which I have configured using a great video from Floob. (I think this site should have a section for all videos, even if just links)

    And this link

    The controller works well in Emulationstation, but doesn’t work in FBA, Mame or snes.

    Is there an extra step for FBS etc?

    Thanks

    #97180

    g0nz0uk
    Participant

    sudo nano XboxGamepad\(userspacedriver\).cfg

    Shows this

    input_device = “Xbox Gamepad (userspace driver)”
    input_driver = “udev”
    input_b_btn = “1”
    input_y_btn = “3”
    input_select_btn = “8”
    input_start_btn = “9”
    input_up_btn = “h0up”
    input_down_btn = “h0down”
    input_left_btn = “h0left”
    input_right_btn = “h0right”
    input_a_btn = “0”
    input_x_btn = “2”
    input_l_btn = “4”
    input_r_btn = “5”
    input_l2_btn = “6”
    input_r2_btn = “7”
    input_l3_btn = “11”
    input_r3_btn = “12”
    input_l_x_plus_axis = “+0”
    input_l_x_minus_axis = “-0”
    input_l_y_plus_axis = “+1”
    input_l_y_minus_axis = “-1”
    input_r_x_plus_axis = “+2”
    input_r_x_minus_axis = “-2”
    input_r_y_plus_axis = “+3”
    input_r_y_minus_axis = “-3”
    input_enable_hotkey_btn = “8”
    input_exit_emulator_btn = “9”
    input_menu_toggle_btn = “2”
    input_load_state_btn = “4”
    input_save_state_btn = “5”
    input_reset_btn = “1”
    input_state_slot_increase_btn = “h0right”
    input_state_slot_decrease_btn = “h0left”
    input_enable_hotkey_btn = “8”
    input_exit_emulator_btn = “9”

    In fba2x.cfg it matches….??

    [Joystick]
    # Get codes from “jstest /dev/input/js0”
    # from package “joystick”
    A_1=0
    B_1=1
    X_1=2
    Y_1=3
    L_1=4
    R_1=6
    START_1=9
    SELECT_1=8
    #Joystick axis
    JA_LR=0
    JA_UD=1

    Confused now

Viewing 2 posts - 1 through 2 (of 2 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

PLEASE NOTE: All orders that are placed between January 14th and January 28th will be shipped on January 29th. Dismiss