Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • shazza6887
    Participant
    Post count: 11

    Hey guys,

    I ordered the control block with the jumpers and the extra large switch. Just need to know what terminals on the switch i need to use. There are 6 connection areas on the switch. I am assuming the 2 included jumper cables get soldered onto these points. I just need to know on point the brown and black wires go on the switch.

    Cheers

    shazza6887
    Participant
    Post count: 11

    No one can help with this one?

    petrockblog
    Keymaster
    Post count: 1827

    You need to connect the wires as following:

    wire 1 o o
    wire 2 o o
           o o

    The colors and the side do not matter.
    A multimeter would be very helpful here to measure the switch state of the switch :-)

    Hope that helps!

    shazza6887
    Participant
    Post count: 11

    Thanks mate!

Viewing 4 posts - 1 through 4 (of 4 total)
  • The topic ‘Wiring switch for control block.’ is closed to new replies.