Tomee SNES USB Exit Issue

Home Forums RetroPie Project Controller Configuration in RetroPie Tomee SNES USB Exit Issue

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of silkypico silkypico 2 years ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #99222
    Profile photo of silkypico
    silkypico
    Participant

    Hey there,

    My SNES USB controllers will not exit with the hotkey+start.

    I’ve run through the retroarch_setup.sh and registered this device and it’s configuration. All of the key mapping works properly in every emulator but the exiting hotkey does not work.

    I’m pretty familiar with this but I normally use GPIO setup.

    In my retroarch.cfg file, if I add the following:
    input_enable_hotkey_btn = “8”
    input_exit_emulator_btn = “9”

    even thought the keymapping is correct, it is causing a conflict. Instead when I’m in a game (NES, Genesis, SNES, PSX, everything except PiFBA), pressing the “X” button on my gamepad will exit the emulator (this is button “0”)

    Retroarch registeres the device as “2Axes11KeysGamePad.cfg”

    I need to figure this out asap because it’s a customer’s unit.

    Please help!

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar