RPi2 image and install by setup.sh

Welcome Page Forums RetroPie Project Everything else related to the RetroPie Project RPi2 image and install by setup.sh

Tagged: ,

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of  Anonymous 2 years, 3 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #92683
    Profile photo of
    Anonymous

    version: 2.6

    before setup.sh:
    snes work fine, but display resolutions is very low, and I don’t know how to configure that. I cannot find out where file is.

    after setup.sh:
    mame/snes work fine, but no any sound.

    other error:
    before setup.sh + install independent
    /opt/retropie/supplementary/runcommand/runcommand.sh line 283 _SYS_ command not found
    All game cannot start.

    any solutions?

    #92688
    Profile photo of petrockblog
    petrockblog
    Keymaster

    after updating do a full binary install.

    #92789
    Profile photo of
    Anonymous

    Solved.

    after updating, edit /boot/config.txt
    hdmi_drive=2
    and reboot, work fine.

    “sudo raspi-config”
    audio output set to hdmi.

Viewing 3 posts - 1 through 3 (of 3 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar