Went through the whole setup, tested and it worked with jstest for BOTH controllers. I added the below lines and mapped them to my corresponding buttons 6 (Select) and 7 (Start). In my case, I would like to exit by holding Start and then tapping Select. The originals given in the tutorial didn’t work for me either.
Tried rom for NES, MegaDrive, Master System and SNES. Unfortunately, none of them are loading properly and return to the EmulationStation.
I burned once again another v3beta4 image onto my SD card and set everything up from a fresh start. Next expanded, firmware update, binary install, updating script, mkjoystick, etc. EmulationStation frontend works flawless with controls.
Cannot boot roms once again. Games will only load if emulator is switched from something NOT named with “lr-“. Not to mention I still haven’t figured the exit hotkey issue from my first post.
I attached the txt/cfg files for retroarch/all and megadrive.
Theres quite a lot of edits in your file:
And some corrupted characters at the end as well. I wouldnt edit that file if I were you. Just use the stock one – if you want to tweak controls use the system based retroarch, or the controller auto file.
Check my vids for an overview on how the configs work.
Try this instead.
– Write a clean RetroPie 3 beta 4 image
(Dont update binaries, script, or anything else)
– Boot it up and try just one rom and see how it goes.
To test one rom you dont even need to expand the filesystem.
RetroPie help guides --> https://goo.gl/Yfy8kj
Please read this before asking for help --> http://goo.gl/eLErnl