Viewing 1 post (of 1 total)
  • Author
    Posts
  • rothdani
    Participant
    Post count: 1

    I’ve a problem with the GPIO Adapter: The SNES Controller is only working in EmulationStation. I can start the Initial Setup in ES and configure the controller, but when I try to save this Initial Setup, I get a Script error.

    I did the following steps:

    1. Used a fresh SD-Card Image
    2. Installed SNESDev driver and library viao Setup-Script
    3. Enabled SNESDev on boot
    4. Removed ES input config
    5. reboot

    Now, ES Starts and I can configure the SNES gamepad for the ES Menu.
    When I then try to configure the controller via Setup-Script with the command line tool, I get only time outs, the controller is not responding in the command line tool.
    Neither in the joystick_configuration tool, nor in the testButton tool from SNESDev.

    Thanks for your support in advance!

Viewing 1 post (of 1 total)
  • The forum ‘Everything else related to the RetroPie Project’ is closed to new topics and replies.