Reply To: Custom 3D Printed Case

Welcome Page Forums RetroPie Project Peoples Projects Custom 3D Printed Case Reply To: Custom 3D Printed Case

Profile photo of smartroad

If someone was to print this at home what is the cost roughly to print it as far as materials go?

The base uses about 20M of filament (50g)
The upper case uses 24M (58g)
The cover uses 18M (44g)

Total of 62 meters or 152g of filament.

Depending on who you buy filament from anything from about £5 up to £10 🙂 Hope this helps 😀

Skip to toolbar