Zune A/V cable, Raspberry Pi 2 and my CRT flicker

Home Forums RetroPie Project Video Output on RetroPie Zune A/V cable, Raspberry Pi 2 and my CRT flicker

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of breakpack75 breakpack75 1 year, 8 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #104024
    Profile photo of breakpack75
    breakpack75
    Participant

    Hey guys! I’m loving my Raspberry Pi 2 and I have just about everything configured to my liking except I’ve been having problems with my display on my CRT TVs. I’m using the Zune a/v cable and notice the screen being a little shaky. It’s especially noticeable when I play a game. When the screen shakes a lot, I really notice the scan lines seperate. I have set the config.txt sdtv_mode to ‘0’ for NTSC. The refresh rate is 60, I set that from within Emulation Station, but I don’t think that’s where the problem is. When I exit into the command prompt, the letters flicker, as they do when I boot up my Pi. Is there some setting that will eliminate the flicker or is that a problem inherent to the Zune a/v cable and 3.5mm to composite cables themselves? I hooked up my original game systems and do not get the flicker. Thanks for any help on this!

    • This topic was modified 1 year, 8 months ago by Profile photo of breakpack75 breakpack75.
    • This topic was modified 1 year, 8 months ago by Profile photo of breakpack75 breakpack75.

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar