Updated Retopie – config changed, but still works

Home Forums RetroPie Project Controller Configuration in RetroPie Updated Retopie – config changed, but still works

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of catmandu13 catmandu13 1 year, 11 months ago.

Viewing 1 post (of 1 total)
  • Author
  • #97670
    Profile photo of catmandu13

    I updated retropie from source. I use a USB controller. Afterwards, found all my settings for my hotkeys still work for the SNES emulator and everything is fine.

    But then I checked my retroarch config…both the “all” and the SNES specific, and a couple ones that weren’t labeled as other emulators.

    None of them had the hotkey setup, nor any of my settings. I had read the configurations would get overwritten, so I was surprised to find my save/load state buttons still worked. Now I’m concerned as to where it’s getting its commands from.

    Any ideas where else to look?

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar