TV Overscanning and Arcade button Controller set up Issue

Home Forums RetroPie Project New to RetroPie? Start Here! TV Overscanning and Arcade button Controller set up Issue

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of cdolliver cdolliver 1 year, 1 month ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #122187
    Profile photo of cdolliver
    cdolliver
    Participant

    Issue Im running into is the overscanning… I enable and disable and cant seem to get emulation station / screens to fit just right.. its on a 19inch crt television I went into the sudo nano /boot/config.txt to change the over scanning settings and cant seem to get that to work either.

    Im still having issues with my control board I am having a very hard time wiring my control board. I am using LED buttons from monster arcades. Half the buttons wont light up and ontop of that the pi wont recognize the breakout that I have. I bought a Screw Break Out Board < click to see. and then go GPIO from the breakout to the pi but for some reason it wont do anything when I click and push buttons? Advice anyone?

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar