SNESDev+GPIO Adapter config?

RetroPie has a new website and forum. Please visit for the new site. The new forum is located at This forum is left here as a read-only archive.

This topic contains 0 replies, has 0 voices, and was last updated by Profile photo of l3rry l3rry 2 years, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
  • #8683
    Profile photo of l3rry


    first of all sorry for my bad english 🙂

    i have some problems with mapping the buttons of an Orginal SNES Controller.
    I connected the GPIO Adapter to the Controller sockets of an SNES Case.
    I activated SNESDev with polling pads & buttons.

    Everythin works fine in emulationstation.
    I also can test the controllers with jstest an they are ok.

    i made some changes in /home/pi/RetroPie/configs/all/retroarch.cfg
    and in /home/pi/RetroPie/configs/snes/retroarch.cfg
    to have the correct mappings for snes.
    but non of the changes happen when i start a rom…

    whitch config do i have to edit?

    I also found /home/pi/RetroPie/emulators/RetroArch/configs/SNES-to-GamepadDevice.cfg

    made some changes in there too, but no changes…

    thanks for help 🙂

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at

Skip to toolbar