Seg Fault when I start Emulationstation

Home Forums RetroPie Project Everything else related to the RetroPie Project Seg Fault when I start Emulationstation

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 5 replies, has 5 voices, and was last updated by Profile photo of foundit foundit 2 years, 1 month ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #2235
    Profile photo of Na An
    Na An
    Participant

    I just installed raspbian on a blank SD card and installed RetroPie. Whenever I start emulationstation all I get is:

    retropie line 11: 2560 Segmentation fault $es_bin “$@”

    Not sure what to do.

    Thanks
    SLK

    #88279
    Profile photo of heikkisorsa
    heikkisorsa
    Participant

    I have the exact same problem and found no solution to this. Any ideas?

    #88280
    Profile photo of InsecureSpike
    InsecureSpike
    Participant
    #88289
    Profile photo of heikkisorsa
    heikkisorsa
    Participant

    I installed it from your link and retropie starts, but at the end it fails to load emulationstation. It gives the error “illegal instruction” as you can see in the attachment

    Attachments:
    #88432
    Profile photo of buzz
    buzz
    Keymaster

    which image did you download from that link ?

    #90918
    Profile photo of foundit
    foundit
    Participant

    Found the problem! You have installed the RetroPie image for Raspberry Pi 2, not B+.
    Install the correct directory here:

    http://blog.petrockblock.com/retropie/retropie-downloads/

Viewing 6 posts - 1 through 6 (of 6 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar