Newb can't folllow xbox 360 config

Home Forums RetroPie Project Everything else related to the RetroPie Project Newb can't folllow xbox 360 config

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 0 replies, has 0 voices, and was last updated by  osouw 2 years, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #9688

    osouw

    Hey All,

    First off, thanks in advance for reading and helping, total noob here.

    I have followed this guide as best as I can however still cannot get my 2 wired xbox 360 controller to work.

    My Setup – I used the Retropie SD Image

    Guide – https://github.com/retropie/RetroPie-Setup/wiki/Setting-up-the-XBox360-controller

    Initial Install – Completed successfully

    Choice of 3 methods (Chose option 1)

    Edited the RC.LOCAL for 2 controllers and saved it.

    Rebooted and used this to verify RPie sees the 360 controller – jstest /dev/input/js[0-3]

    Now here is where I am stuck, under config in RetroPie configuration I try to find this folder but cannot find it
    cd ~/RetroPie/emulators/RetroArch/installdir/bin/

    Further, I am unsure what to add to this document .. RetroPie/configs/all/retroarch.cfg

    So when I boot up, even with both controllers on, the system still says No Joystick detected.

    Again, thanks!

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar