NES Controller to GPIO

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of joostvanpoppel joostvanpoppel 2 years, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #9784
    Profile photo of joostvanpoppel
    joostvanpoppel
    Participant

    So, after a week trying by myself I gave up hope of getting it done 🙁
    I can’t seem to get my NES-controller working with RetroPie…
    I CAN get it to work with the WiringPi package, but not with gamecon or snesdev.

    Im using other pins on the GPIO as pre-scribed by the RetroPie package. I’m using the following pins on my rev2 board.
    P1: 3.3v
    P5: Data
    P6: Ground
    P11: Clock
    P12: Latch
    These worked with the WiringPi software.

    Is there any way I can change the pins to be used by gamecon/snesdev?
    Second question: is there any NES-controller driver, not integrated with the RetroPie package, that you guys know of?

    Any help will be greatly appreciated!

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar