Mayflash wireless PS3 adapter

Home Forums RetroPie Project Controller Configuration in RetroPie Mayflash wireless PS3 adapter

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of kaaven kaaven 1 year, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #99319
    Profile photo of kaaven
    kaaven
    Participant

    I’m trying to find a solution to my problem.

    Using the Mayflash adapter (Product link) I get one fully working wireless controller and are happy. It is recogonized as a XBOX controller. But if I want to use more than one, I need to change from “Xinput” to “Dinput” on the adapter, and then none of them work.

    Is there a way to use this adapter to connect more PS3 controllers? This is the cheapest adapter I found that support ps3 controllers flawlessly.

    From the producers hompage on D- and X-input:
    “If the Input Switch is set to the “Direct Input” mode, the controllers are recognized as standard Human Interface Device. Your controllers can be calibrated at the Windows Gamepad Setup screen. Up to four controllers can be recognized by a single adapter while in this mode.”

    “Setting the switch to “Xinput Mode” will make it possible to fool certain PC games which lock out proper input modes from the user unless an Xbox controller is attached (for a list of these games, check Wikipedia). While in Xinput Mode Vibration Feedback is available. The drawback is that while in this mode, only one controller can be recognized by the adapter.”

    • This topic was modified 1 year, 10 months ago by Profile photo of kaaven kaaven. Reason: Added info from producers homepage

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar