GPIO Adaptor using original SNES connectors

Home Forums RetroPie Project Everything else related to the RetroPie Project GPIO Adaptor using original SNES connectors

RetroPie has a new website and forum. Please visit for the new site. The new forum is located at This forum is left here as a read-only archive.

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of randomalias randomalias 2 years, 6 months ago.

Viewing 1 post (of 1 total)
  • Author
  • #82111
    Profile photo of randomalias

    Hi Guys,

    Before I acquire the GPIO adaptor I was wondering if anyone had successfully hooked it up to an original SNES controller connector plate yet (the one that would normally be hooked up by a ribbon cable to the SNES mobo)?

    Would you need to remove the PCB and wire straight to the pins as normal or is there other shenanigans required? Failing that, is there any way to make the original PCB/ribbon combo work with the Raspberry Pi at all?


Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at

Skip to toolbar