got Control Block wired up…now what???

Home Forums RetroPie Project GPIO Adapter, ControlBlock etc. got Control Block wired up…now what???

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of bobchiba bobchiba 1 year, 9 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #102537
    Profile photo of bobchiba
    bobchiba
    Participant

    Hi,

    Just got my lovely control block assembled and wired up to original SNES controller board and have just re-installed all the binaries again from retropie setup screen.

    I am a bit of a noob when it comes to issuing commands on the back end; on the main site is says I must setup the control block service (or driver?) before it will work. How do I do this, I have no idea how to edit cfg files etc.

    **ALso on a side note, My rocker switch turns the Pi on (which is good)but then it does nothing after this despit switching it back.forth and the led is always glowing slowly?

    Thanks in advance for your help

Viewing 1 post (of 1 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar