Emulation Station Not Booting

Home Forums RetroPie Project Everything else related to the RetroPie Project Emulation Station Not Booting

RetroPie has a new website and forum. Please visit https://retropie.org.uk/ for the new site. The new forum is located at https://retropie.org.uk/forum/. This forum is left here as a read-only archive.

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of sselph sselph 2 years, 2 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #88722
    Profile photo of stoleyourface210
    stoleyourface210
    Participant

    Hello all I would like to start off by saying that I am rather new to all of this and just started using Raspberry Pi with Retro Pie. I was using Retro Pie v1 for a few days with success when I decided to wile the SD card and install v2. The problem is once I updated to v2 Emulation Station no longer boots. Here is what happens. When I plug in the raspberry pi it runs through code like usual and I get the Retro Pie Gaming project like always. Then it runs through more code like it usually does, and then when it would normally boot to the Emulation Station loading screen it instead stays in the code screen. You know, where you can manually type in commands yourself. This never happened when I had v1 installed on my SD card, only since I wrote the v2 image to the card. Any help would be greatly appreciated! Just try to keep in mind that I am a noob when it comes to all of this, although I am very good at following instructions! Thanks again for reading, hopefully we can get this sorted out!

    – Jay

    #88740
    Profile photo of Floob
    Floob
    Moderator

    Dont forget that

    2.6.0 v1 is for B+ (and 1st series of Raspberry Pi A, A+, B, B+)
    2.6.0 v2 is for the Raspberry Pi 2 Model B (The new one)

    Does that help?

    RetroPie help guides --> https://goo.gl/Yfy8kj
    Please read this before asking for help --> http://goo.gl/eLErnl

    #88741
    Profile photo of sselph
    sselph
    Participant

    You could connect a keyboard and try entering the command
    $ emulationstation
    If that works then it just isn’t booting to ES and you could fix it by doing:
    $ sudo ~/RetroPie-Setup/retropie_setup.sh
    Under Setup there is an option to Auto-Start EmulationStation

    Auto-scraper: https://github.com/sselph/scraper

Viewing 3 posts - 1 through 3 (of 3 total)

Forums are currently read only - please visit the new RetroPie forums at https://retropie.org.uk/forums/

Skip to toolbar